Accessible Wade extruder pusher
11
Likes
1013
Downloads
3197
Views
Published on January 2, 2013
Description
This is the extruder pusher which goes on top of an x-carriage.
It was adjusted for Arcol.hu hotend v4, link:
blog.arcol.hu/?p=1979
And goes on top of the x-carriage, thing:39923: thingiverse.com/thing:39923
For the full setup, please refer to this detailed article/howto: blog.arcol.hu/?p=1991
--
This thing is based on thing:17030, thing:6703.
The modifications are really minor, basically size adjustments (holes, nuts, etc). I also added skirt for warpless printing (from ABS), from pla it is not an issue.
The license is the same as the ancestors.
It was adjusted for Arcol.hu hotend v4, link:
blog.arcol.hu/?p=1979
And goes on top of the x-carriage, thing:39923: thingiverse.com/thing:39923
For the full setup, please refer to this detailed article/howto: blog.arcol.hu/?p=1991
--
This thing is based on thing:17030, thing:6703.
The modifications are really minor, basically size adjustments (holes, nuts, etc). I also added skirt for warpless printing (from ABS), from pla it is not an issue.
The license is the same as the ancestors.
Instructions
No instructions provided.
More from laszlo
More from 3D Printer Extruders
What is the advantage of it? I mean seriously, any dealbreaker? It wear less? It is quiter? None of it is a real issue. Besides you can print your own gear once you assembled this. Of course its a simple swap-out.