Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
KichenAid Adapter Bearing Housing
1
Likes
88
Downloads
483
Views
Published on January 1, 2013
Derived from
Kitchenaid Mixer Attachment Cap
by MiseryBot
Description
This cap fits over the attachment hub of a KitchenAid stand mixer and houses a bearing. It is for stabilizing DIY KitchenAid attachments. I use it with a Milescraft drill adapter coupling (http://www.thingiverse.com/thing:39960).
More information: absurdlycertain.blogspot.com/2012/07/update-2-diy-hario-conical-burr-grinder.html
Available on Shapeways: shapeways.com/search?q=kitchenaid
More information: absurdlycertain.blogspot.com/2012/07/update-2-diy-hario-conical-burr-grinder.html
Available on Shapeways: shapeways.com/search?q=kitchenaid
Instructions
I use it with a 3/8" x 5/8" x 5/32" sealed, pre-lubricated ball bearing from VXB. Note that out of 2 different bearings purchased, only the one with the blue race seal fit in the printed housing, even though both bearings were supposed to have the same dimensions within tolerance...
License
KichenAid Adapter Bearing Housing by Chinasaur is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.