Loading

Azteeg X3 adapter for RAMPS mounting holes

by sgraber, published

Azteeg X3 adapter for RAMPS mounting holes by sgraber Jan 2, 2013

Description

In case you have RAMPS mounting holes on a frame but want to mount an Azteeg X3 board in its place instead. Use this and you're set.

Recent Comments

view all

Random though, but if some bridges were made across the parralel parts on each side, we'd have a convenient point to ziptie wire down that would run under the board. Maybe even on all four sides. I imagine this would make for a cleaner end result.

LOOK OUT, he is on a roll.

Good stuff and it will help out the community a lot. :)

More from 3D Printer Accessories

view more

Makes

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Print. Mount plastic part using RAMPS holes. Mount Azteeg X3 board. Done.

I made this after seeing the "Sanguinololu adapter for RAMPS mounting holes" by Sound: thingiverse.com/thing:39893.

NOTE: The Azteeg X3 board hole spacing was obtained from files.panucatt.com/datasheets/x3_wiring_diagram.pdf

Comments

You must be logged in to post a comment.

Anonymous on Jul 19, 2013 said:

Random though, but if some bridges were made across the parralel parts on each side, we'd have a convenient point to ziptie wire down that would run under the board. Maybe even on all four sides. I imagine this would make for a cleaner end result.

Anonymous on Jan 2, 2013 said:

LOOK OUT, he is on a roll.

Good stuff and it will help out the community a lot. :)

Top