Pittsburgh Dial Indicator Holder with 8mmx2mm Magnets
3
Likes
99
Downloads
745
Views
Published on January 5, 2013
Description
This dial indicator holder can be used with a Pittsburgh 1" dial indicator and 8mm diameter x 2mm thick, rare earth magnets. It was built for an analog indicator. However, I believe the dimensions of Pittsburgh's digital 1" dial inidicator are the same.
The STL was modified using Blender 2.65.
The STL was modified using Blender 2.65.
Instructions
I followed the instructions found here:
thingiverse.com/thing:28725
NOTE: The feet on my print aren't parallel for some reason. But, they attach to the X-axis rails perfectly. So, it shouldn't be an issue.
thingiverse.com/thing:28725
NOTE: The feet on my print aren't parallel for some reason. But, they attach to the X-axis rails perfectly. So, it shouldn't be an issue.
License
Pittsburgh Dial Indicator Holder with 8mmx2mm Magnets by rabbittech is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Parts
You must be logged in to post a comment.