Single extruder Makerbot replicator leveling post
0
Likes
108
Downloads
631
Views
Published on January 5, 2013
Description
This levels the top piece of the extruder so it doesnt hang down on the one side. I added a nylon washer next to the heated block and the post.
Not sure if it was supposed to come with some thing similar from makerbot but mine looked like crap until I put these on
Not sure if it was supposed to come with some thing similar from makerbot but mine looked like crap until I put these on
Instructions
25% fill
1 shell
1 nylon washer on bottom next to heated block.
Print 2 to cover both bolts
1 shell
1 nylon washer on bottom next to heated block.
Print 2 to cover both bolts
License
Single extruder Makerbot replicator leveling post by wdelarme is licensed under the Attribution - Share Alike - Creative Commons license.
More from wdelarme
More from 3D Printer Parts
You must be logged in to post a comment.