Loading

Horned Owl

by cerberus333, published

Horned Owl by cerberus333 Jan 5, 2013

Description

Horned Owl

Modeled in sculptris
flat bottomed in Truespace5

Recent Comments

view all

Uploaded a picture!

Looking forward to seeing the prints!
This is one of my favorite efforts so far.

I just printed this.. It's great! The detail on the feet is impressive. It took 4hrs with Sailfish 1 shell + 1 perimeter, 5% infill @ 80mm/s.

I'm printing another one and will Acetone vapour them! I'll post pictures once complete.

More from Animals

view more

Liked By

view all

Tags

License

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

no support should be needed
Infill at 10%
Printed in ABS with infill as posted.


If doing 0% infill i suspect after print gaps would be fixable in ABS with abs/acetone goop
I tend to lean towards 0% infill as it prints faster, uses less plastic
but I don't mind the touchups. ABS would be my preference in 0% settings

for PLA and Nylon I would go with the infill.

Comments

You must be logged in to post a comment.

Fastrack on May 24, 2013 said:

I just printed this.. It's great! The detail on the feet is impressive. It took 4hrs with Sailfish 1 shell + 1 perimeter, 5% infill @ 80mm/s.

I'm printing another one and will Acetone vapour them! I'll post pictures once complete.

cerberus333 on May 25, 2013 said:

Looking forward to seeing the prints!
This is one of my favorite efforts so far.

MichaelAtOz on Jan 5, 2013 said:

Maybe you should have gone 'no derivatives', I'm probably not the only one who went to Horny Owl...

cerberus333 on Jan 5, 2013 said:

hmm i am guessing horny owl website is not a wildlife site
(assuming wildlife in the Audubon society sense)

Top