iPad Magnetic Mount
14
Likes
285
Downloads
1145
Views
Published on September 9, 2010
This thing was Featured on September 9, 2010
Description
A corner bracket to mount an iPad to something flat. Gives the slightest bit of clearance beneath the back of the iPad and the thing you are mounting it to. Glue some strong magnets to each corner for a quick and dirty iPad refrigerator mount! Print it on it's side to print without supports...
****Bonus****
Also part of the upcoming iPad Pinball Machine...
****Bonus****
Also part of the upcoming iPad Pinball Machine...
Instructions
Print 4 of these and glue a large neodymium disk magnet to the back of each. you can also just drill a hole in the solid part and use a screw to mount it to a piece of wood or something. I am planning on adding a groove or guideholes to use a drawstring to keep it on the corners of the ipad.
License
iPad Magnetic Mount by Linkreincarnate is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from Linkreincarnate
You must be logged in to post a comment.