Cat Toy

by theroar, published

Cat Toy by theroar Jan 5, 2013

Thing Info

3616Views 821Downloads Found in Pets
Report Thing


I am interested in a cat toy that is large enough that it will not go under our couch. The sad look on our kittens face just tears me up... and I have to bend down to get the toy back. =)


Printed at 5 percent with a custom piece of rafting. It just is a small cylinder that allows the ball to print without coming off the plate.

Once printed, I bust the ball off on the inside with my finger. Too lazy to take a ruler upstairs with me, so this is the 4th time I guesstimated the correct size of a non-lose able ball... I am up to 6cm in diameter. =)

More from Pets

view more

Thing Info

3616Views 821Downloads Found in Pets
Report Thing


Liked By

View All


Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

I used ABS on this one. Cannot remember if I used raft. I am always frugal with the plastic, so I know I did not use supports. It was orignially printed on a original replicator. I have not tried it on my Rep2 or 2x. I think it would be fine with either ABS or PLA, but cannot guarantee it.

Does this needs to be printed with support? is PLA ok? Or should it be printed on ABS?

MIne lasted till last week when the cable guy accidentally stomped it while hooking up a cable tuner.... Cat loved it. Time to print a new one I guess.

i should give this to my obsessive cat friend to give to her cat.

My cats will love this

I can confirm that the ones in my house are still played with. =) Except of course the one I stepped on... =)