Expand-i-Hook - The expandable test lead organizer
by apgeesci, published
An expandable hook system for organizing banana plug and other test leads.
Recent Commentsview all
One possible flaw is that the stress on the tines is along their weakest plane. It's always easier to delaminate a printed part than to break it along any other plane. This problem is exacerbated by the fact that you've printed the tines as a bunch of small islands, which on many FDM printers end up weaker due to temperature fluctuations induced by the slow feedrate. If you want to get a lot of use out of these, you should come up with a way to print the tines flat, and then maybe slot them into a wall mount part.
Liked Byview all
Give a Shout Out
I have included the sketchup file and STL. Dimensions are in millimeters.
If there is enough interest, I will print some to sell.
Suggestions, questions? Post em' below.
You must be logged in to post a comment.