Loading

Nexus 7 stand - compact

by msurguy, published

Nexus 7 stand - compact by msurguy Jan 7, 2013

Description

This is a Nexus 7 stand that uses less plastic than the original

Recent Comments

view all
Just printed this today - took about an hour and a half on the Afinia, with the inside set to nearly hollow (it's still pretty sturdy).

One thing to note - as-is, my Nexus 7 (2012) didn't actually stand up very well. However, I cut a strip of black electrical tape the length of the front lip, and stuck it to the inside, then wrapped it up and over, and now it holds perfectly!

More from Tablet

view more

Makes

Liked By

view all

License

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Make sure to print with low perimeter speed because the curves might not be laid slow enough to stick to bottom layer.

Just printed this today - took about an hour and a half on the Afinia, with the inside set to nearly hollow (it's still pretty sturdy).

One thing to note - as-is, my Nexus 7 (2012) didn't actually stand up very well. However, I cut a strip of black electrical tape the length of the front lip, and stuck it to the inside, then wrapped it up and over, and now it holds perfectly!
Top