Satnav Clamping for MEDION® GoPal® P5460 EU+
0
Likes
117
Downloads
297
Views
Published on January 7, 2013
Description
Since I unfortunately broke the genuine clamping of my navigation system, I designed a replacement. This clamping is designed for the model "MEDION® GoPal® P5460 EU+".
Instructions
Printed with:
Prusa Mendel
ABS filament
Nozzle: 0.5 mm @ 210°C
on polyamid tape (Kaptonband) coated glass carrier @ 90°C
The printed part did fit well onto the genuine window carrier. Before clamping the setnav into the printed clamping I recommend adding the rubber pad from the genuine clamping. It will fit into the notch of the printed clamping.
Prusa Mendel
ABS filament
Nozzle: 0.5 mm @ 210°C
on polyamid tape (Kaptonband) coated glass carrier @ 90°C
The printed part did fit well onto the genuine window carrier. Before clamping the setnav into the printed clamping I recommend adding the rubber pad from the genuine clamping. It will fit into the notch of the printed clamping.
License
Satnav Clamping for MEDION® GoPal® P5460 EU+ by Uinsel is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.