Brush holder
6
Likes
472
Downloads
823
Views
Published on January 8, 2013
Description
My brshes were just lying arond everywhere, so I made this holder. I don't know if it is the best solution but it works for me. Designed to be made from 4mm material, I used plywood but I'm sure acrylic would also look pretty good.
Instructions
Just in case my CAD program messed everything up, here are the dimensions for the files: top_bottom.dxf: 140x70mm; sides.dxf: 268x70mm; dividers.dxf: 248x140mm
1. Cut everything out. You need to cut every file only once.
2. Glue it together as shown in the picture.
3. Use it! ;)
1. Cut everything out. You need to cut every file only once.
2. Glue it together as shown in the picture.
3. Use it! ;)
You must be logged in to post a comment.
License
Brush holder by ripper is licensed under the Attribution - Non-Commercial - Creative Commons license.
You can also cut them out of Lexan, which will hold up to an accidental drop on the floor.