Speaker Mount
0
Likes
103
Downloads
364
Views
Published on January 7, 2013
Description
I bought a lot of a bazillion little speakers on eBay and needed a mount for them.
This is a simple ring mount to hold the speaker. Use it on another project to add a simple mount.
This is a simple ring mount to hold the speaker. Use it on another project to add a simple mount.
Instructions
This probably will not fit your speaker. Tweak the openscad parameters to suit your device.
cylIr is the radius of the speaker
cylHole is the opening of the mount
holdingRimH is the thickness of the retaining ring holding the speaker in
after getting something that fit my speaker, I then tweaked the tabOffset to moving the retaining bumps towards or away from the center until the speaker was held in tightly.
cylIr is the radius of the speaker
cylHole is the opening of the mount
holdingRimH is the thickness of the retaining ring holding the speaker in
after getting something that fit my speaker, I then tweaked the tabOffset to moving the retaining bumps towards or away from the center until the speaker was held in tightly.
License
More from mkellner
More from Electronics
You must be logged in to post a comment.