by Uinsel, published
This house was designed as pice of the boardgame "Kingdom Builder" but might be used for several other boardgames too.
Nozzle: 0.5 mm @ 220 Â°C
carrier: glass (no coating)
Skeinforge parameter advice:
It's best to use "Multiply" or arrange several of those small houses in one print run.
If only one house is printed it will either overheat or the printing time is increased massively when using the "Cool" option.
I tried 3 different parameter settings.
The best results were achieved with a "Solid Surface Thickness" of 1 (just for reducing the amount of used material) and 1 "Extra Shell on Sparse Layers" but with "Infill Solidity" of 0.0. This causes the house to be empty inside but with 2 shells.
The other 2 parameter settings used only 1 shell but with an "Infill Solidity" of either 0.25 or 0.0. Printing with only 1 shell resulted in lots of holes in the roof of the houses. However already an "Infill Solidity" of 0.0 seems sufficiently sturdy.
Liked ByView All
Give a Shout Out
boardgame house by Uinsel is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure Uinsel would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).