A Spool holder for miniFactory
by lindstorm, published
A simple, no-support printable spoolholder for miniFactory 3D printer.
This Spool holder consists of 2 parts, and is attachable (and removable, and re-attachable... :D) without any screws or tools. Just push the spool holder through the hole in miniFactory's upper right corner, and push the holder pin through the spool holder axis to lock it in place.
It holds most of the spools, smaller and bigger ones. It has very little friction so the spool runs smoothly on it. It's also located so, that the filament will run from it into feeder without any extra parts, even when making higher prints.
There's now a shorter version of the Spool Holder, that works better with spools that have thinner edge. Also, The lock-part has been enhanced so, that you can use the spool holder on either side of miniFactory 3D printer - or Both, if that's what you want :)
Liked ByView All
Give a Shout Out
A Spool holder for miniFactory by lindstorm is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving lindstorm a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure lindstorm would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).