Weekly cup nr1
79
Likes
749
Downloads
4024
Views
Published on January 8, 2013
This thing was Featured on January 14, 2013
Description
New Year new intentions...! This year i will upload a new cup every week. This is number one...! Done in Blender, which was quite difficult for me to figure out how to get this pattern on the cup. The trick is displacement mappings and a lot of persistence, but then you can create the most beautiful objects.
Instructions
Download, slice and print. This one was sliced with cura with "joris" activated in the expert settings at a pretty low resolution 0,25mm layer height. 1MM outer wall, 0,8mm nozzle, 1,2mm bottom thickness, no top.
print time: 23 minutes, 52 seconds
see also:
www.rooiejoris.nl
facebook.com/europerminutedesign
print time: 23 minutes, 52 seconds
see also:
www.rooiejoris.nl
facebook.com/europerminutedesign
You must be logged in to post a comment.
License
Weekly cup nr1 by joris is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from joris
More from Kitchen & Dining
how did you print that in 23 minutes? must be an insane speed setting? I use ultimaker with marlin but I don't see how i could get below 45min or something like this.
For most of my designs I use a bigger nozzle [0.8mm] and a radial fan to cool the material a bit faster...