Raspberry Pi 3, 2 or B+ Case
by Normand, published
-Easy access to every connector
-Breakable GPIO opening
-Internal mounting holes (4x M2x10 or M2x14)
-Micro SD card does not protrude but still accessible
-Compatible with Raspberry Pi 3, 2 and B+
Raspberry Pi 3, 2 and B+ version have enough power to run a wifi usb stick, 3d printer and logitech camera without another powered usb hub. Reduce the amount of wires around an OctoPrint setup.
Printed with a Solid Utopia V2 at 0.150mm layer height, 100/120mm/s
2015-01-21 I uploaded a new version with more gap between the usb port and the pcb and more clearance under pcb. The fasteners pad have more strength too.
Printed with a Solid Utopia V2
-0.150mm layer height
4x M2x10 screw or M2x14
Liked ByView All
Give a Shout Out
Raspberry Pi 3, 2 or B+ Case by Normand is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure Normand would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).