Chile coin organizer/counter -- monedas de Chile
0
Likes
63
Downloads
249
Views
Published on January 9, 2013
Description
For holding and counting Chilean coins.
Para organizar y cuentar monedas Chilenos.
Para organizar y cuentar monedas Chilenos.
Instructions
Warning: this model is taller than 100mm. You may encounter bad mojo if your printer cannot print higher than 100mm.
The design was made for reprap, so I had to enlarge the small coin tubes to fit properly. Higher-res printers may print the holes too big but the coins should still not fall out. Each tube should hold 50 of each coin.
Built in 3dsMax.
Imprimir y disfrutar :)
Hecho para Reprap, puede ser que los tubos de las monedas chicas son un poco grande. Entonces, cada tubo tienen capacidad para 50 monedas de cada tipo.
The design was made for reprap, so I had to enlarge the small coin tubes to fit properly. Higher-res printers may print the holes too big but the coins should still not fall out. Each tube should hold 50 of each coin.
Built in 3dsMax.
Imprimir y disfrutar :)
Hecho para Reprap, puede ser que los tubos de las monedas chicas son un poco grande. Entonces, cada tubo tienen capacidad para 50 monedas de cada tipo.
License
Chile coin organizer/counter -- monedas de Chile by 3dGringo is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3dGringo
More from Organization
You must be logged in to post a comment.