MakerBot Napkin Holder
13
Likes
711
Downloads
252
Views
Published on September 18, 2010
This thing was Featured on September 18, 2010
Description
My wife saw Zydacs MakerBot Taco Holder (thing:4090) and said why dont you make me a napkin holder? Oh, and by the way make it red so it matches the walls.
So here it is, enjoy.
So here it is, enjoy.
Instructions
I printed napkin_100917a.stl. It is oriented so that feet align with the strands in the raft for maximum adhesion and minimum warping. However, the raft overlaps the flathead screws in my build platform.
If you have the standard protruding head, socket head cap screws in your build platform use file napkin_100917a_rotated.stl. this file is rotated 90 degrees to avoid the screws.
If you have the standard protruding head, socket head cap screws in your build platform use file napkin_100917a_rotated.stl. this file is rotated 90 degrees to avoid the screws.
License
MakerBot Napkin Holder by tc_fea is licensed under the Attribution - Share Alike - Creative Commons license.
More from tc_fea
I use either an Exacto knife or a Dremel to clean up all the fuzz :)