Y-Axis Belt Mount for MendelMax 1.5
Description
Added belt clamps instead of cable ties. Sized for GT2 2mm pitch 6mm wide timing belt which is standard on the MendelMax.
Instructions
Hardware required:
8 M3 10mm screws (four for mounting and four for clamps)
4 M3 Nuts
Print and insert nuts into the nut traps before mounting. Clamp one end of the belt, run the belt around motor and idler, pull tight and clamp the free end.
8 M3 10mm screws (four for mounting and four for clamps)
4 M3 Nuts
Print and insert nuts into the nut traps before mounting. Clamp one end of the belt, run the belt around motor and idler, pull tight and clamp the free end.
You must be logged in to post a comment.
License
Y-Axis Belt Mount for MendelMax 1.5 by MishaT is licensed under the Attribution - Creative Commons license.
More from MishaT
More from 3D Printer Parts
if possible please could you email me the solidworks file? (hallomotto64@hotmail.com) It would be very helpful to be able to change some of the dimensions of the mount before 3D printing it. Thanks
I'll send them to you after work, but you should probably remove your email address from the comment (I have it written down).