Case for 3.5" LCD from Adafruit
10
Likes
66
Downloads
1006
Views
Published on February 21, 2013
Description
This is a protective case for the NTSC LCD screen listed here on Adafruit.
adafruit.com/products/913
It is designed like the PiBow in layers.
The parts are pretty delicate when you cut them but when put together it is a lot stronger than the LCD panel by itself.
adafruit.com/products/913
It is designed like the PiBow in layers.
The parts are pretty delicate when you cut them but when put together it is a lot stronger than the LCD panel by itself.
Instructions
Use 1/16 “ acrylic.
I split cutting into 3 layers to allow cooling and to keep all holes in place until outside cut is made.
Parts 4 and 5 require you to fit the controller board through the slot.
4 Small holes on outside edge are for 3/4” x 2-56 screws.
I split cutting into 3 layers to allow cooling and to keep all holes in place until outside cut is made.
Parts 4 and 5 require you to fit the controller board through the slot.
4 Small holes on outside edge are for 3/4” x 2-56 screws.
License
Case for 3.5" LCD from Adafruit by smallgod is licensed under the Attribution - Share Alike - Creative Commons license.
More from DIY
You must be logged in to post a comment.