Belt mount for Galaxy S2 with power case.
by eddiema, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
Similar to my wall mount but takes a 32ish mm belt.
It is not a "clip" - the belt is fully captive.
This mount fits my power case - S2s without the case won't fit. Other makes of the case may or may not work.
I used it in earnest today and it worked very well. The phone sits a little higher than it did using the leather belt clip case and the new position is better when pedalling a bike.
The corners can be a it sharp so I've done beltthing2 with them rounded. It slices OK but I haven't printed it.
Tested and seems to fit quite well. Printing .2mm in PLA resulsted in functional but ugly overhangs - ABS will probably print better.
I had my wall mount version fall over when printing the past few layers so I used a PVA coating on the bed to print this one - it worked but was hard to remove.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Belt mount for Galaxy S2 with power case. by eddiema is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving eddiema a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure eddiema would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).