Loading

Nema 11 Stepper Motor Mount

by lach11, published

Nema 11 Stepper Motor Mount by lach11 Jan 13, 2013

Description

I recently had a project which allowed only very little space width-wise and so was using a nema 11 stepper motor. Accordingly, I needed a slim mount for the stepper motor and this seemed to do the trick. Has three offset fixing hole just in case splitting (on the mounting surface) is an issue.

Recent Comments

view all

almost, but given my extremely tardy response, i can point you here - http://www.thingiverse.com/thi.... otherwise, a proverb springs to mind - “Tell me and I'll forget; show me and I may remember; involve me and I'll understand.” To that end, easiest and cheapest place to start is here - http://www.sketchup.com/intl/e.... The rest is up to your imagination.....lach 11.

Hi sealyons, i havent used Repetier-Host so may not much help on that front. quick google revealed a similar issue with units conversion for someone else. My .skp was done in metric and exported to .stl. see here - http://www.soliforum.com/topic.... also reprap forum talks about some potential firmware related matters - http://forums.reprap.org/read..... all else fails start from the .skp using your respective units (metric v imperial) and go from there. cheers lach11

Having trouble with the sizing. The default sizing when I load the .stl (using Repetier-Host) is REALLY SMALL. What do I need to scale this to in order to get it printing at the correct size for NEMA-11? Appreciate any help.

More from Electronics

view more

Liked By

view all

Tags

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Comments

You must be logged in to post a comment.

sealyons on May 21, 2013 said:

Having trouble with the sizing. The default sizing when I load the .stl (using Repetier-Host) is REALLY SMALL. What do I need to scale this to in order to get it printing at the correct size for NEMA-11? Appreciate any help.

lach11 on May 28, 2013 said:

Hi sealyons, i havent used Repetier-Host so may not much help on that front. quick google revealed a similar issue with units conversion for someone else. My .skp was done in metric and exported to .stl. see here - http://www.soliforum.com/topic.... also reprap forum talks about some potential firmware related matters - http://forums.reprap.org/read..... all else fails start from the .skp using your respective units (metric v imperial) and go from there. cheers lach11

deviant on Mar 7, 2013 said:

is it too much to ask if you can make a nema 17 holder? i'm new here, don't have experience... i would really appreciate it... if not, it's still cool to see stuff like this :D thanks!

lach11 on May 28, 2013 said:

almost, but given my extremely tardy response, i can point you here - http://www.thingiverse.com/thi.... otherwise, a proverb springs to mind - “Tell me and I'll forget; show me and I may remember; involve me and I'll understand.” To that end, easiest and cheapest place to start is here - http://www.sketchup.com/intl/e.... The rest is up to your imagination.....lach 11.

Top