Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
1 Piece Hand Stop
20
Likes
647
Downloads
7726
Views
Published on January 14, 2013
Description
Hand stop compatible with standard MIL-STD-1913 rails. Put between two Magpul XTM panels, or print the screw model and attach where you want!
Hardware for screw model:
mcmaster.com/nav/enter.asp?partnum=90685A039
mcmaster.com/nav/enter.asp?partnum=92981A050
Hardware for screw model:
mcmaster.com/nav/enter.asp?partnum=90685A039
mcmaster.com/nav/enter.asp?partnum=92981A050
Instructions
Print at 20% fill, .27 layer height for best results.
You must be logged in to post a comment.
License
1 Piece Hand Stop by Caboose is licensed under the Attribution - Share Alike - Creative Commons license.
More from Caboose
More from Sport & Outdoors
On a printed rail section, it seems slightly too large? Even with a screw through it, I can still slide it....
I have tested these on both Troy, KAC, and other rails. I think your printed rail might be a bit off. I also had a guy who runs it on his Midwest Industries AK rail. Can you measure your printed rail with calipers?