Levitation Illusion Model
by devonelliott, published
Screw Lift Aga based on a design in Bruce Armstrong's Encyclopedia of Suspensions and Levitations (Calgary: M. Hades International, 1976). http://www.worldcat.org/oclc/4467299
Print two of the base files -- these will be the top and bottom of the main apparatus. You also need a threaded M8 rod, two 608 bearings, and five M8 nuts. Four pieces, equal in length, cut from a quarter-inch square dowel are used as supports between the bases. A section of coat hanger goes between the captive nut piece and the brace. The small brace is designed for a StickFa figure. The coupler is designed to fit the M8 threaded rod and a Solarbotics GM2 gear motor. The motor is controlled with an Arduino and DPDT relay. Drill out the holes to fit the rod; sandpaper can help for smoother finishes and to help get the dowels in. Your StickFas will need some sort of stage to perform it on.
Liked ByView All
Give a Shout Out
Levitation Illusion Model by devonelliott is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving devonelliott a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure devonelliott would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).