iPhone 5 Wall / Dashboard Mount
by GigaGremlin, published
I'm using one of those Leather case with flip cover and was bored to change the cover for using in my car or night stand etc.
So I've made one for the IP5 with my usual cover. A very important point for me was to use it open and closed and of course charge it inside the mount. It's meant to be used with one of this cheap sticky phone pads for car dashboard, but if you print it with 66% Infill, you can also drill a Hole through...
To use it, first slide the top side in like the angel of the little rampe and the lower the bottom inside the mount and behind the edges. No force needed. :-)
My Replicator 2 seems to work only with Skeinforge as slicer and manual changed Infill, Shells and Layer Height, otherwise I would recommend Medium or even Low Quality Standard-Profile from MakerWare...
The one from the Pictures was built in Skeinforge with 66% Infill, 3 Shells and 0.25 Layer Height and it came out very solid
Liked ByView All
Give a Shout Out
iPhone 5 Wall / Dashboard Mount by GigaGremlin is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure GigaGremlin would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).