SOLIDOODLE_PEEK_DRILL_JIGS
1
Likes
66
Downloads
556
Views
Published on January 16, 2013
Description
SOLIDOODLE_PEEK_DRILL_JIGS TO DRILL OUT PLUGGED PEEKS
Instructions
Use these to unplug SD PEEKS using a #19 (0.0689)drill.
Usually the hot end side is all that is needed to be drilled.
Usually the hot end side is all that is needed to be drilled.
You must be logged in to post a comment.
License
SOLIDOODLE_PEEK_DRILL_JIGS by pcpoirier is licensed under the Attribution - Non-Commercial - No Derivatives license.
More from pcpoirier
More from 3D Printer Accessories
My Solidoodle is wondering what this is for.
If you've ever had molten plastic back up far enough in the hot end that it starts to fill the PEEK tube (black plastic heat break) and then, for whatever reason, had to remove and disassemble your hot end then you'd know :-).
Basically it's a drill guide you stick into the PEEK tube so you can drill out the plastic blockage without damaging the PEEK tube.
...I'm pretty sure.