Defense wall for wargaming
by KellyBC, published
A model of a defense wall for miniature wargaming. It is scaled for 28mm by default. the front section is 3 inches wide and the wings are 1.5 inches long each.
You can try printing this as one piece, but I have also provided three independent pieces that should print flat and glue together.
I printed one of these today and the wings are tapered just enough so that a stair stepping effect occurs on the front face of each wing. It isn't too bad, it sort of looks like seams in the metal, but wanted you to be aware. I will post pictures when I get a chance so you can see the printed model. If it isn't too hard to change the model, I will see if I can eliminate the stepping.