Parametric simple PCB bracket
0
Likes
247
Downloads
465
Views
Published on January 17, 2013
Description
Just an L bracket with groove to hold PCBs. Configurable left and right groove stops (corners), pcb height and width, height off mounting surface, screw size, etc. Automatic calculation of number and spacing of screws
EDIT: I thickened up the upright a little, it was kind of weak in the notch area. Also widened the default groove a little. Should be better now.
EDIT: I thickened up the upright a little, it was kind of weak in the notch area. Also widened the default groove a little. Should be better now.
Instructions
Use these STLs as is - one is a bracket for the usbpicprog card (untested) (print two), the others are generic left, right and center PCB holders, print however many of whatever you need.
Or use the SCAD file to generate custom brackets to fit different PCB sizes and mounting situations.
You can use the "inner" parameter to make the screw bit go UNDER the PCB - but if you want that on both sides you'll have to leave a corner open or perhaps bend the plastic out to get the board in.
Or use the SCAD file to generate custom brackets to fit different PCB sizes and mounting situations.
You can use the "inner" parameter to make the screw bit go UNDER the PCB - but if you want that on both sides you'll have to leave a corner open or perhaps bend the plastic out to get the board in.
License
Parametric simple PCB bracket by jridley is licensed under the Attribution - Creative Commons license.
More from jridley
More from Electronics
You must be logged in to post a comment.