Mendel90 extended bottom PSU bracket
0
Likes
78
Downloads
440
Views
Published on January 18, 2013
Description
i was unable to use the PSU that is normally supplied with the build kit in the US. The one I used was slightly larger than the designed brackets. (Not much, about 4mm)
This was created by hacking the original scad files available on github to extend the mount points out 5mm. This also makes the brackets even with the edge of the base and gantry.
I would provide the modified scad file, but it was truly a hack job. The right way would be to define a slightly larger power supply in the electronics config file.
This was created by hacking the original scad files available on github to extend the mount points out 5mm. This also makes the brackets even with the edge of the base and gantry.
I would provide the modified scad file, but it was truly a hack job. The right way would be to define a slightly larger power supply in the electronics config file.
Instructions
Print and replace the supplied ATX bottom bracket with this one.
License
Mendel90 extended bottom PSU bracket by daichiasuka is licensed under the Attribution - Share Alike - Creative Commons license.
More from daichiasuka
More from 3D Printer Parts
You must be logged in to post a comment.