Loading

Objet Cartridge Transfuser

by PrototypeAsia, published

Objet Cartridge Transfuser by PrototypeAsia Jan 19, 2013

Description

Are you tired of wasting the last 100g of resin because you can't reload an almost empty cartridge in the printer ?

And what about the last 250g of cleaning solution ?

We are, and we made this.

Simply pop this device between two Objet 1Kg cartridges of resin, support or cleaner; and the top cartridge will safely empty in the bottom one, without exposing the contents to air or light.

Works with all cartridges made for the :
Objet 24
Objet 30
Objet 30 Pro
Objet 30 Scholar

Before each use
A. Soak in IPA (in an ultrasonic cleaner)
B. Let dry thoroughly

After each use
A. Clean thoroughly with the Water jet (careful uncured resin and support are corrosive)
B. Soak in IPA (in an ultrasonic cleaner)
C. Let dry thoroughly

Disclaimer: We are not responsible for any damage to your material or printer as a result of the use, and mis-use, of this device. This device is not an authorised device and might void your manufacturer warranty. Use at own risk.

More from 3D Printer Accessories

view more

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

1. Print in glossy mode with the dividing plane firmly horizontal (auto placement puts it slanted)
2. Clean with the Water jet (this wont clear the pipes)
3. Clean with an ultrasonic cleaner using 10% Caustic Soda solution
4. Clean with the Water jet until water passes through the pipes unobstructed.
5. Clean with an ultrasonic cleaner using 10% Caustic Soda solution
6. Clean thoroughly with the Water jet to get every last bit of support out of the pipes.
7. Use a flat file to sharpen the tips as much as possible (otherwise it wont pass through the rubber)
Top