clamp style x end stop for 10mm rails on 50mm centers
4
Likes
74
Downloads
658
Views
Published on January 19, 2013
Description
I upgraded to 10mm rails and a quick fit x carraige so i needed to save as much room as i could. i designed this Clamp style mechanical end stop holder to do that. the holes for the switch are 9mm On center and accept a M2.5 screw..
NOTE:
these will not work with 8 mm rods they will never clamp on.
NOTE:
these will not work with 8 mm rods they will never clamp on.
Instructions
print 2
drill out support material on little holes nut trap.
Screw on limit switch with 2 m2.5 screws,
clamp both ends on x rails with M3 screws.
as a note i had to print with a brim to keep the ends from warping off the bed when printed with ABS, its not the best geometry to atempt to print with ABS but with a 3mm brim it worked fine.
drill out support material on little holes nut trap.
Screw on limit switch with 2 m2.5 screws,
clamp both ends on x rails with M3 screws.
as a note i had to print with a brim to keep the ends from warping off the bed when printed with ABS, its not the best geometry to atempt to print with ABS but with a 3mm brim it worked fine.
License
clamp style x end stop for 10mm rails on 50mm centers by xochal is licensed under the Attribution - Share Alike - Creative Commons license.
More from xochal
More from 3D Printer Accessories
You must be logged in to post a comment.