Printrbot Pen Holder (Repaired)
5
Likes
63
Downloads
497
Views
Published on January 19, 2013
Derived from
Printrbot-Plotter Marker Mount
by TheGrum
Description
I wanted to try the Printrbot Pen Holder but it needed repair to slice correctly (at least in Slic3r). Based on the comments, I wasn't the only one who noticed so all I did to this was repair the STL file. It prints fine.
Instructions
See original part. I made NO changes to V3 except to fix it in Netfabb.
License
Printrbot Pen Holder (Repaired) by wd5gnr is licensed under the Attribution - Share Alike - Creative Commons license.
More from wd5gnr
More from 3D Printer Accessories
You must be logged in to post a comment.