Parametric Sanguinololu Encl. Remix
7
Likes
197
Downloads
595
Views
Published on January 20, 2013
Derived from
Parametric Sanguinololu enclosure
by ckaos
Description
Original by ckaos.
The original wasn't quite complete so I added some options and fixed the default layout.
The original wasn't quite complete so I added some options and fixed the default layout.
Instructions
OpenSCAD file attached so you can roll your own.
- Reduced the duct. The fan will move enough air.
- No duct so I don't think you need the capacitor hole. Made it optional.
- Mirrored Top to fit properly.
- Added option to put holes in the top so you can bolt it together. I used zip ties and haven't reprinted this with the holes. I think the idea was to snap fit but mine won't stay together via friction. There might not be enough headroom depending on your specific components.
- Reduced the duct. The fan will move enough air.
- No duct so I don't think you need the capacitor hole. Made it optional.
- Mirrored Top to fit properly.
- Added option to put holes in the top so you can bolt it together. I used zip ties and haven't reprinted this with the holes. I think the idea was to snap fit but mine won't stay together via friction. There might not be enough headroom depending on your specific components.
You must be logged in to post a comment.
License
Parametric Sanguinololu Encl. Remix by TheBogueRat is licensed under the Attribution - Share Alike - Creative Commons license.
More from TheBogueRat
More from 3D Printing
Good case!