Case for softrock radio
6
Likes
102
Downloads
539
Views
Published on January 20, 2013
Description
This is a enclosure for the Ensemble rx II purchased from fivedash.com/
Details of the radio design use can be found on wb5rvz.org/ensemble_rx_ii
Details of the radio design use can be found on wb5rvz.org/ensemble_rx_ii
Instructions
Print a top and case, case screws will hold the PCB in place.
Warping can be a problem with any object that has a sizable flat bottom, take normal precautions.
I used PLA on a Makerbot v1 197C/50C and was able to get it dimensionally correct with minimal warping.
Warping can be a problem with any object that has a sizable flat bottom, take normal precautions.
I used PLA on a Makerbot v1 197C/50C and was able to get it dimensionally correct with minimal warping.
License
Case for softrock radio by jsaffer is licensed under the Attribution - Share Alike - Creative Commons license.
More from jsaffer
More from Electronics
You must be logged in to post a comment.