Sliced Human Skull with Mandible and Teeth
by MacGyver, published
Recent Commentsview all
Printed (with Kisslicer) the Mandible with 100% scale and a 0.3mm noozle, didnt worked that good, its a bit too smale. The Teeths are too smale, maybe better with 150% scale.
I've printed 3 or 4 without any issues so far. I'm printing them on my Thing-O-Matic using Sailfish firmware and ReplicatorG. I didn't create this model I only sliced it so I could print it.
Liked Byview all
Give a Shout Out
There is an alternate Mandible Top that has a strap for a rubber band. So if you screw a hook in the bottom of the skull then you can use that strap to hold the mandible on.
I got the original from Grabcad and then sliced it up to print. grabcad.com/library/skull-1
You must be logged in to post a comment.