Fan guard for 40 mm fan
by SVAPS, published
This is a guard to keep fingers and filament out of the fan I will place on my extruder.
I found that the fan only had a guard on the outlet side facing the extruder and not on the inlet side facing the rest of the world, so I made one.
Print the guard (it takes only a few minutes and 14 cm of 3 mm filament) and attach it with two or more screws through the fan and into the fan mount of your choosing. The holes should fit the standard holes in most 40 mm fans.
Liked ByView All
Give a Shout Out
Fan guard for 40 mm fan by SVAPS is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure SVAPS would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).