Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Pin For 'Printed Micro-Hexapod'
2
Likes
50
Downloads
594
Views
Published on January 21, 2013
Description
Another trifle, really :)
Use this for connecting the front- and hind legs to the cross bars instead of screws or wire for this project:
thingiverse.com/thing:34796
Use this for connecting the front- and hind legs to the cross bars instead of screws or wire for this project:
thingiverse.com/thing:34796
Instructions
Print with support and a resolution of .1mm, 0 shells, 60% filling.
You may have to resize the pins to actually fit Your holes.
Use the pins to connect the joints and then melt the end up. I used my solder iron for that. Stinks a lot and is as toxic as we all think it is ;)
Deform the pin's end so that the joint is held in place.
Make sure You don't fuse the pin with the joint :)
I have put some plastic washers between the parts.
Please have a look at the pictures...
You may have to resize the pins to actually fit Your holes.
Use the pins to connect the joints and then melt the end up. I used my solder iron for that. Stinks a lot and is as toxic as we all think it is ;)
Deform the pin's end so that the joint is held in place.
Make sure You don't fuse the pin with the joint :)
I have put some plastic washers between the parts.
Please have a look at the pictures...
License
Pin For 'Printed Micro-Hexapod' by hyla is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.