Exelpet Fleaban flea collar buckle
2
Likes
97
Downloads
466
Views
Published on January 21, 2013
Description
When you buy these flea collars they're big enough to fit huge dogs. We've got two small
dogs, so I designed this to save on wastage of the trimmed collar.
Designed for: "Exelpet Fleaban water resistant 5 month flea collar for dogs"
All Excelpet branding property of Exelpet Australia: exelpet.com.au
dogs, so I designed this to save on wastage of the trimmed collar.
Designed for: "Exelpet Fleaban water resistant 5 month flea collar for dogs"
All Excelpet branding property of Exelpet Australia: exelpet.com.au
Instructions
Cut the collar to fit the bigger dog, then print one of these. I used 0.2mm layer
height. Drill a 3mm hole about 5mm from the end of the buckle-less piece, and use a
3mm pop rivet to attach the printed piece to the collar. Make sure the smooth, domed
side of the rivet is on the inside so as to not irritate the dog, like the
factory-produced buckle.
height. Drill a 3mm hole about 5mm from the end of the buckle-less piece, and use a
3mm pop rivet to attach the printed piece to the collar. Make sure the smooth, domed
side of the rivet is on the inside so as to not irritate the dog, like the
factory-produced buckle.
License
Exelpet Fleaban flea collar buckle by tjhowse is licensed under the Creative Commons - GNU GPL license.
You must be logged in to post a comment.