Vase Figurine Scan test
by aubenc, published
Test scan using the PC version of Autodesk's 123D Catch.
I used MeshLab to take a look to the output, Meshmixer to close the holes and OpenSCAD to make it flat.
Slice and Print :)
I printed both at 0.15mm layer height, 60mm/s, ReplicatorG 0039 - Sailfish, no support or special settings.
The red one (non-scaled) printed without any flaws. The are some little strings falling down in the severe overhangs in the white one, scaled up 2x, but I'm very pleased with the result anyway.
Liked ByView All
Give a Shout Out
Vase Figurine Scan test by aubenc is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving aubenc a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure aubenc would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).