Toyota Prius Wheel Center Cap - ZAP
4
Likes
44
Downloads
541
Views
Published on January 22, 2013
Description
This thing was made with Tinkercad.
If you have a Generation III Prius (2010-present), you can pop off the UGLY wheel covers to release the alloy beasts underneath. Except - you'll have a hole in the center of the wheel that begs for a decorative cap. This is precisely measured from the Toyota part number 42603-52110 (pictured).
This has a stylized lightning bolt embossed in the top of the wheel cover.
Also fits Yaris, Vios
These and other center cap designs are available through Shapeways:
shapeways.com/shops/bitforge?section=Prius+Wheel+Center+Caps&s=0
If you have a Generation III Prius (2010-present), you can pop off the UGLY wheel covers to release the alloy beasts underneath. Except - you'll have a hole in the center of the wheel that begs for a decorative cap. This is precisely measured from the Toyota part number 42603-52110 (pictured).
This has a stylized lightning bolt embossed in the top of the wheel cover.
Also fits Yaris, Vios
These and other center cap designs are available through Shapeways:
shapeways.com/shops/bitforge?section=Prius+Wheel+Center+Caps&s=0
Instructions
I'm not sure how these WILL print - I am sure that they will need support. Experimentation is in order. The dimensions are as accurate from the original part as I could get, but the diameter may need to be squidged a bit for a proper snug fit. Disclaimer- you print and use this part at your own risk.
Collections
CNC Machines
by antonzedd
Spare parts and ways to repair things
by Fruktodlaren
Things to Make
by chuckolot
License
Toyota Prius Wheel Center Cap - ZAP by schlem is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.