Power switch support for Prusa Mendel (i2)
14
Likes
288
Downloads
1016
Views
Published on January 22, 2013
Derived from
Power Cord Support
by foxdewayne
Description
The support is 32 mm wide and fits the Prusa Mendel frame. I scavenged the power switch (26 x 26 mm) from an old PC. I was adding a power supply to my Prusa Mendel and found the Power Cord Support which this part is derived from. I used that part for a power cable and modified it to hold a power switch.
Instructions
Print the support and use Zip ties to attach it to the threaded rods like in the picture.
License
Power switch support for Prusa Mendel (i2) by rmoro is licensed under the Attribution - Non-Commercial - Share Alike license.
More from rmoro
More from 3D Printer Accessories
You must be logged in to post a comment.