Dentelle Ceiling Lamp done with OpenSCAD and printrbot
17
Likes
342
Downloads
950
Views
Published on January 22, 2013
Description
nice ceiling lamp done with OpenSCAD and printrbot
Instructions
All OpenSCAD files are available for printing and the slic3r configuration for the printrbot as well.
Headbed: 50°c (just to make the double face tape more gluey)
Extruder: 215°c
Filament: PVC
Be very carefully with any open door or windows - close it and increase the heater of the room to at least 23°C or put your printrbot into a box. If you have any temp. changes your print will fail (crancks).
The metal cap on top can be found with google or on eBay goo.gl/qBqW3
Headbed: 50°c (just to make the double face tape more gluey)
Extruder: 215°c
Filament: PVC
Be very carefully with any open door or windows - close it and increase the heater of the room to at least 23°C or put your printrbot into a box. If you have any temp. changes your print will fail (crancks).
The metal cap on top can be found with google or on eBay goo.gl/qBqW3
You must be logged in to post a comment.
License
Dentelle Ceiling Lamp done with OpenSCAD and printrbot by FreeGroup is licensed under the Attribution - Share Alike - Creative Commons license.
Woo. This gives me renewed hope for my beat up Printrbot. Great project! Thanks for taking the time to post this.