Filament Guide
3
Likes
83
Downloads
603
Views
Published on January 22, 2013
Description
This is about as simple as you can get. It's a 200mm long stick that clips onto your threaded rods. I prefer this design because the filament is allowed to slide side to side.
Instructions
Print this at an angle unless you can print 200mm long objects. I used 45 degrees on a 200mm bed.
Once printed, clip onto the top of your prusa mendel. :)
Once printed, clip onto the top of your prusa mendel. :)
More from engineglue
More from 3D Printers
You must be logged in to post a comment.