Race Car
22
Likes
1222
Downloads
1997
Views
Published on January 22, 2013
This thing was Featured on January 23, 2013
Description
Students had to do a group project to create a multi-part toy using Solid Edge. Our prototyping process and tolerances were incorporated into the design process. This car was created by Harvey, Karl, and Keith.
Instructions
Printed on our Makerbot Replicator Dual using red and blue PLA, 190 extruder temp, 0 bed temp, .2 layer height
Wheels - 40% infill, 1 shell (4 needed)
Locks - 100% infill, 0 shells (4 needed)
Axels - 100% infill, 0 shells (4 needed)
Back - 40% infill, 1 shell
Engine - Support, 40% infill, 1 shell
Front - Support, 40% infill, 1 shell
Chair - Support, 40% infill, 1 shell
There is a .2 mm difference between holes and pegs for friction fit. There is a .5 mm difference between the wheel hole and the axle for a slightly looser fit to allow for rotation of the wheels about the axle.
Wheels - 40% infill, 1 shell (4 needed)
Locks - 100% infill, 0 shells (4 needed)
Axels - 100% infill, 0 shells (4 needed)
Back - 40% infill, 1 shell
Engine - Support, 40% infill, 1 shell
Front - Support, 40% infill, 1 shell
Chair - Support, 40% infill, 1 shell
There is a .2 mm difference between holes and pegs for friction fit. There is a .5 mm difference between the wheel hole and the axle for a slightly looser fit to allow for rotation of the wheels about the axle.
License
Race Car by CentaurDesign is licensed under the Attribution - Share Alike - Creative Commons license.
More from CentaurDesign
More from Toys & Games
You must be logged in to post a comment.