Toyota Prius Wheel Center Cap - Power Symbol
by schlem, published
This thing was made with Tinkercad.
If you have a Generation III Prius (2010-present), you can pop off the UGLY wheel covers to release the alloy beasts underneath. Except - you'll have a hole in the center of the wheel that begs for a decorative cap. This is precisely measured from the Toyota part number 42603-52110 (pictured).
This has the iconic power symbol embossed in the top of the wheel cover, as found on the power button of your Prius. More info: http://en.wikipedia.org/wiki/Power_symbol
Also fits Yaris, Vios
These and other center cap designs, for GenII and GenIII are available through Shapeways:
This work is licensed under the Creative Commons - Attribution - Non-Commercial license. This license applies only to the files and documents available for download from the Thing Files section of this Thing.
All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license. with all rights reserved, unless specifically available for download This notice constitutes a clarification, not a change, to licensing for this design.
Liked Byview all
Give a Shout Out
I'm not sure how these WILL print on an extruder type machine- I am sure that they will need support. Experimentation is in order. The photographs are of sintered-nylon samples printed by Shapeways.
Disclaimer- you print and use this part at your own risk.
Painting ABS is fairly straight forward: just rough it up a bit with some fine sandpaper and hit it with a few light coats of your preferred body paint. No primer necessary.