Magnificent Mendel Prusa Power Supply Adjustable Cradle Mount (aka MPPSACM)
0
Likes
134
Downloads
456
Views
Published on January 23, 2013
Description
Greetings All,
Submitted for your RepRap 3D printing convenience, this simple mount was built to hang the power supply for my Prosa from by the threaded rods.
Submitted for your RepRap 3D printing convenience, this simple mount was built to hang the power supply for my Prosa from by the threaded rods.
Instructions
The design of the large holes is for the M8 metric threaded frame rod and the slots are for M4 screws.
Some power supplies have mounting screws on one side and not on the other, so a small L angle bracket can be used as a shelf on one side if needed.
The power supply I used (from Amazon) is 12v 30A and a bit on the large size so with the mounts added just fits between the stabilizer and frame vertices. This one measured 114mm wide by 50mm high, by 215mm in length.
Features:
• Large holes for mooting on M8 threaded frame rod.
• Small holes are all M4 for attaching the mount locking clips and power supplies.
• Made from ≈3mm acrylic sheet.
• Small locking "clips" to hold the mount to the M8 rod.
Laser Settings:
• Speed: 20
• Power: 90
• Freq: 5000
A second pass may be needed (my second pass settings: S= 35, P=75, F = 5000). I'm sure this could be dialed in a bit more.
Some power supplies have mounting screws on one side and not on the other, so a small L angle bracket can be used as a shelf on one side if needed.
The power supply I used (from Amazon) is 12v 30A and a bit on the large size so with the mounts added just fits between the stabilizer and frame vertices. This one measured 114mm wide by 50mm high, by 215mm in length.
Features:
• Large holes for mooting on M8 threaded frame rod.
• Small holes are all M4 for attaching the mount locking clips and power supplies.
• Made from ≈3mm acrylic sheet.
• Small locking "clips" to hold the mount to the M8 rod.
Laser Settings:
• Speed: 20
• Power: 90
• Freq: 5000
A second pass may be needed (my second pass settings: S= 35, P=75, F = 5000). I'm sure this could be dialed in a bit more.
License
Magnificent Mendel Prusa Power Supply Adjustable Cradle Mount (aka MPPSACM) by daschick is licensed under the Attribution - Creative Commons license.
More from 3D Printer Accessories
You must be logged in to post a comment.