22mm Bimini Hood Clip
by dansto, published
An clip to hold the frame of the hood together when not extended on my boat (Four Winns Vista 298) - original on one side obviously ended up in the drink at some point.
Was fun removing the inner geometry, i'm a bit of a Sketchup newb... I copied the OEM part but changed it a little aesthetically (because i could!)
Printed on its side - the support is a pain to remove, but the lateral strength is needed for it to hold securely to the poles on not snap when its clipped on. Amazingly strong and solid feeling though.
Liked ByView All
Give a Shout Out
22mm Bimini Hood Clip by dansto is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure dansto would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).