Huxley dual 70mm fan mount
2
Likes
128
Downloads
701
Views
Published on January 24, 2013
Derived from
Reprappro Huxley 120mm fan mount
by MarkBenson
Description
Fan mount for Huxley-sized 3D-printers (eMaker, RepRapPro, ...) to be used with two 70mm fans.
Instructions
I had a few old 70mm fans from old computers laying around and decided to create/modify a fan mount to use them with my Huxley.
If you want to do it the same way than I did, you will need the following parts:
4 of each: connector.stl, mounting.stl
8 M4 nuts
8 M4x25 bolts
4 M3 nuts
4 M3x16 bolts
Screw all together, mount it to your printer, connect fans with your electronics, update software and slicing settings, print and enjoy new printing quality - it's so easy ;-)
If you want to do it the same way than I did, you will need the following parts:
4 of each: connector.stl, mounting.stl
8 M4 nuts
8 M4x25 bolts
4 M3 nuts
4 M3x16 bolts
Screw all together, mount it to your printer, connect fans with your electronics, update software and slicing settings, print and enjoy new printing quality - it's so easy ;-)
License
Huxley dual 70mm fan mount by 3DAndy is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3DAndy
More from 3D Printer Accessories
You must be logged in to post a comment.