Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Yet an another Z coupler !
1
Likes
123
Downloads
513
Views
Published on January 25, 2013
Derived from
Mendel Prusa Z Coupling
by ArjanG
Description
I was inspired by thingiverse.com/thing:35564 but i found it a bit ...too big, with useless use of plastic
so I design this one to self centered, with just the amount of plastic to be strong enough to keep the nuts and screws in place
designed for 5mm stepper axe and 8 mm threaded rod
with inside guide for the axe and rod to be perfectly centered
need 6 3mm 8-10 mm screws and 6 nuts each (on the picture I had only 16 mm screws)
so I design this one to self centered, with just the amount of plastic to be strong enough to keep the nuts and screws in place
designed for 5mm stepper axe and 8 mm threaded rod
with inside guide for the axe and rod to be perfectly centered
need 6 3mm 8-10 mm screws and 6 nuts each (on the picture I had only 16 mm screws)
Instructions
I printed mine 0.2mm high, 0.49mm wide 0.6 infill in ABS (i found PLA a bit brittle for this kind of job)
License
Yet an another Z coupler ! by jfpion is licensed under the Attribution - Share Alike - Creative Commons license.
More from jfpion
More from 3D Printer Parts
You must be logged in to post a comment.